0
£0.00
|
Precision dosing valves with a needle assembly to dispense precise dots or very fine beads of low to medium viscosity adhesives and fluids such as anaerobics, activators, inks, gels, solvents, lubricants, chemicals and UV's. Needle seal at tip end prevents dead space for very fast shut off when dispensing micro dots without drips. Needle valves are designed to apply micro shots without drips. The valve design is vertical with fluid flow from the side either by syringe, cartridge or fluid line feed (from pressure pot). Use black fluid lines or feed tubing with UV cure adhesives. |
|
Part ID:
TS5420SS
Materials:
303 Stainless Steel, Teflon Seals
Size:
4.40" (111.8mm) L x 1.10" (28.5mm) Diameter
Weight:
4.8oz
Viscosity Range:
1 - 100,000 CPS
Repeatability:
±0.3%
Cycle Rate:
Up to 500 cycles/ minute
Flow Rate (water):
1680ml/min @ 100 psi
Min Shot Size:
0.003 cc/ ml
Max Fluid Pressure:
300 psi (21 Bar)
Activation Pressure:
70 psi (4.8 bar) minimum
Material Inlet:
1/8" NPT
Material Outlet:
Male Luer Lock
Mounting:
1/4" 20UNC-2B
Lead Time:
* Ships in 1-2 Business Days
Use our valve selection guide page or click here for PDF datasheet selection guide. Precision valves will dispense accurate deposits direct from syringes, cartridges or pressure pots. Valves operate with minimal maintenance, ensuring clean and accurate dispensing whether used by hand, fixed on a production line or mounted onto an XYZ robot.
